E-83
Programming PLU functions in a lump
This method programs functions of a PLU at one time.
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>
▪▪▪▪▪
>
F
2 Enter 3 and press o key to set the register in the
programming mode.
3o
3 Enter four-digit PLU number then press
PLU/
S.DEPT
key. 0014
PLU/
S.DEPT
For example, to program PLU number
fourteen.
4 Referring the table in the previous section, input 12- digit
program code.
BB▪▪▪▪▪BB
[Program code (12 digits)]
5 Press F key.
F
6 Repeat steps 3 through 5 if you wish to program functions
in another PLU.
7 Press o key to complete the program.
o
Advanced programmings and registrations
To Next Page
Loading...
Need help?
General
