5.2.1 CASH, CHARGE, CHECK, CREDIT
Title Value
Key Code
Primary keycode of this key.
Func Code
CASH function code is 000001.
CHARGE function code is 000002.
CHECK function code is 000003.
CREDIT function code is 000004.
Descriptor
Name of this key.
Tender type Selects a limitation of tendering.
0: Allow tendering
1: Prohibit tendering
2: Force tendering
3: Allow tendering but no partial payment
4: Force tendering and no partial payment
5: Prohibit tendering and no change payback
6: Force tendering and no change payback
Last digits
restriction
Limits lower digit number of tendered amount entry.
0: No limit
1: 5
2: 10
3: 50
Change limit Limits amount of change.
Prohibits tendered amount entry if the change will be more
than the set amount. Setting zero is considered as no limit.
When using this setting together with change amount zero
limitation, it judges by the change amount before setting
forced zero.
Preset amount tender Assigns preset tendered amount. Setting zero is defined as
no setting.
Drawer open Assigns drawer control.
1: Open
2: Not open
No change due is made Defines whether setting change amount zero forcibly or
not.
0: No (calculate the change amount and pay it back)
1: Yes (change becomes zero and no payback)
Enter No. of checks Assigns whether to input number of checks depending on
its value or not. When using this feature, set the tendered
amount as the value of the check.
Number of receipt Number of receipts to be issued.
0： 1 receipt
1～3： One to three receipts
40
To Next Page
Loading...
