To reset the altitude calibration value
1.
Perform steps 1 through 3 under “To perform altitude
reading calibration manually”.
2.
Tap C.
Important!
●
Using the above procedure to reset the correction value causes the watch
to display altitude values that are simply calculated based on International
Standard Atmosphere
(ISA) definitions. Because of this, there will be large
error between displayed values and actual altitude. After reset, it is
recommended that you perform the steps under “To perform altitude
reading calibration manually” again.
To enable or disable altitude calibration according to
smartphone location information
1.
Perform step 1 under “To perform altitude reading
calibration manually”.
2.
Tap D to display the setting menu.
3.
On the setting menu, tap
“Correct Altitude Using
Location
” to change its setting.
●
Each tap of the menu item toggles the setting between “ON” and
“OFF”.
4.
To close the setting menu, swipe the touch screen from
left to right.
EN-88
To Next Page
Loading...
Need help?
General
