EasyManua.ls Logo

Casio XJ-V2 - Page 41

Casio XJ-V2
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
Command List
Only the following functions are supported while the projector is turned off. Do not try to send any
other command to the projector.
Input of a valid signal must be in progress in order to use a command to turn on blank screen or
change the aspect ratio.
R: Read enabled W: Write enabled
Power on/off: Read
Power on: Write
Get light time: Read
Function
Command
Name
RW Setting Range
Power On/Off: PWR RW 0: Off, 1: On
Input Switching: 0: Switches the input source to the
COMPUTER terminal and changes the
COMPUTER terminal setting to RGB.
1: Switches the input source to COMPUTER
terminal and changes the COMPUTER
terminal setting to component.
6: Switches the input source to COMPUTER
terminal and changes the COMPUTER
terminal setting to Auto.
7: Switches the input source to HDMI.
SRC RW 0: RGB, 1: Component,
6: Auto (RGB/Component),
7: HDMI
Blank Screen: Switches the blank screen on or off. BLK RW 0: Off, 1: On
Volume: Specifies a value to adjust the volume level. This
setting is applied to the input source signal that is
currently being projected by the projector.
VOL RW 0 to 30
Color Mode: Selects the color mode. PST RW 1: Graphics, 2: Theater,
3: Standard, 4: Blackboard,
5: Natural
Aspect Ratio: Specifies the aspect ratio. ARZ RW 0: Normal, 1: 16:9, 4: Full,
7: 16:10 (when RGB or HDMI
(PC) is selected for input)
1: 16:9, 2: Normal, 6: 4:3,
7: 16:10 (when Component or
HDMI (DTV) is selected for
input)
Get Light Time: Gets the light time from the projector. LMP R 0- Unit: Hours
Eco Mode: Enter Eco Mode. PMD RW 0: Off (Bright), 1: Off (Normal),
3: On (Manual 1),
4: On (Manual 2),
5: On (Manual 3),
6: On (Manual 4),
7: On (Manual 5)
Freeze: Switches freeze on or off. FRZ RW 0: Off, 1: On
Keystone Correction:
Specifies the keystone correction setting as a value that
corresponds to the typical Setup Menu “Keystone
Correction” settings below.
0: Keystone Correction –60
60: Keystone Correction 0
120: Keystone Correction +60
Example: 65 here, specifies a setting equivalent to
Keystone Correction +5.
KST RW 0 to 120

Table of Contents

Related product manuals