Pairing the Presenter Mic and the Receiver
Catchbox Plus Receiver can be paired with up to two Transmitters simultaneously. To reduce the setup
time each Transmitter and Receiver unit have been paired in the factory before shipping.
Pairing two devices
1. Make sure that both devices are turned on and located within 3 m / 10 ft distance from
each other.
2. On the Presenter Mic simultaneously press and hold both volume <<+>> and <<->> buttons.
3. LED on the Presenter Mic will display a sequence indicating that it is in Pairing mode and
looking for a Receiver.
4. While Presenter Mic is in the Pairing mode press Pairing button on the Receiver.
5. Wait until connection is established.
6. Once devices are paired the LEDs on both devices will light up steadily and the audio
signal will be passed from the Presenter Mic to the Receiver.
Unpairing the devices
1. Press and hold the Pairing button on the Receiver until Mic Status LEDs start blinking.
2. Wait for the pairing information to be cleared from all devices. Both Mic Status LEDs on the
Receiver will turn off. All Transmitters will be disconnected from the Receiver.
To Next Page
Loading...
Need help?
General