What to do if my CATH-TECH Hexcorder Pro Measuring Instruments unit won't take readings?
If your CATH-TECH Measuring Instruments unit won’t take readings, try the following: 1. Switch the half cell poles to address a potentially bad switch. 2. Switch the half cell cables to address a potentially broken cable. 3. Check for manual survey mode.
What to do if the CATH-TECH Hexcorder Pro unit won’t respond when in survey mode?
If the unit won’t respond when in survey mode, power cycle the Hexcorder Pro and reconnect to the tablet.
How to fix a CATH-TECH Hexcorder Pro Measuring Instruments unit that reads very low ON/OFF values?
To address very low ON/OFF values, check all connections, including: * Half cell pole cables * Wire dispenser cable * Wire spool to wire dispenser * Survey wire to test post * Ensure caps are removed from half cells * Verify distilled water is in half cells
What to do if CATH-TECH Measuring Instruments GPS won’t lock?
If the GPS won’t lock, ensure a good view of the sky, free from trees and buildings. Also, check that the GPS is plugged in correctly.
What to do if the CATH-TECH Measuring Instruments tablet won’t turn on?
If the tablet won’t turn on, plug it in using the tablet AC power adapter. If the power LED lights up but there is no screen display, the screen might be broken.
How to fix CATH-TECH Measuring Instruments unit that won’t take readings?
If the unit won’t take readings: * Switch half cell poles (bad switch) * Switch half cell cables (broken cable) * Check for manual survey mode
Why does my CATH-TECH Hexcorder Pro Measuring Instruments unit read very low ON/OFF values?
If your CATH-TECH Measuring Instruments unit reads very low ON/OFF values, check all connections including half cell pole cables, wire dispenser cable, wire spool to wire dispenser, survey wire to test post, ensure caps are removed from half cells, and verify distilled water is in half cells.
What to do if CATH-TECH Hexcorder Pro Measuring Instruments unit won’t respond in survey mode?
If your CATH-TECH Measuring Instruments unit won’t respond when in survey mode, power cycle the Hexcorder Pro and reconnect it to the tablet.
Why won't the GPS lock on my CATH-TECH Hexcorder Pro?
If the GPS on your CATH-TECH Measuring Instruments unit won’t lock, make sure it has a clear view of the sky, free from obstructions like trees or buildings. Also, check that the GPS is correctly plugged in.
How to fix a CATH-TECH Measuring Instruments Hexcorder Pro that won’t turn on?
If your CATH-TECH Measuring Instruments Hexcorder Pro won’t turn on, the most likely cause is a dead battery. Try plugging it in using the AC power adapter.
Provides instructions and notes on charging the Hexcorder Pro and tablet batteries.
Explains the function, accuracy, and connection of the GPS engine.
Describes the screen for configuring survey options like operator, survey type, and units.
Covers survey types, sync, units, trigger, start, and direction configurations.
Describes the three alarm features (Low Potential, Broken Wire, DCVG Defect).
Details time zone, cycle time, off time, on/off first, and delay time configurations.
Explains the five configurable "widgets" for the survey screen layout.
Details the setup and procedure for conducting a CIPS survey.
Explains the measurement principles and procedures for DCVG and ACVG surveys.
Discusses combining CIPS and DCVG surveys for comprehensive data.
General| Brand | CATH-TECH |
|---|---|
| Model | Hexcorder Pro |
| Category | Measuring Instruments |
| Language | English |
To Next Page