CCV IM30 - EVA SDM Cut-out Installation

Manual - CCV IM30
14
5.3 Installation based on the EVA SDM cut-out
The dimensions correspond to those of a standard
door module (SDM) as defined by the European
Vending Association (EVA). In this case, the supplied
EVA mounting frame (CCV part number 03442-55) is
used to mount the terminal.
The M4 bolts should protrude from the back of the
mounting plate so that the mounting frame can be
inserted.
The illustration on the right shows the terminal rear
view including positioning of the holes for
mounting the terminal.
The following figures illustrate the positioning of the holes for mounting and the method of mounting.
Important
Mounting the 4xM4 screws has to be done with a force torque of 0,8 Nm ±0,2 Nm..