CDA hn3620

11
To turn the power o
To switch o a single zone, touch the “Selection” key for the zone no
longer required. Touch the “-” key until the zone display shows zero.
When both zones are at zero, the hob will switch o automatically
after approximately ten seconds.
Alternatively, to switch o the hob immediately, touch and hold the
key for approximately two seconds.
Timer
The hob is equipped with a timer that allows a finish time to be set for
the end of cooking on either or both zones, between a minimum of
one minute and a maximum of 99 minutes. This timer can be used
independently for dierent times on each zone.
To set the timer
• Switch on the power.
• Touch the “Zone selection” key for the zone required, then set the
power level by touching the “+” or “-” keys within ve seconds, as
above.
• Touch both the “+” and “-” keys at the same time to select the timer.
The timer display will show “00”.
• Set the required duration using the “+” or “-” keys within ve
seconds. Touching the “-” key will go straight to 30 minutes. Touch
and hold the timer “+” or “-” keys to scroll through the duration
quickly.
• After approximately ve seconds, the control LED stops ashing
and the countdown will start.