EasyManuals Logo

CDA hn3620 User Manual

CDA hn3620
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
IMPORTANT:
When correctly installed, your product meets all safety
requirements laid down for this type of product. However, special
care should be taken around the rear or the underneath of the
appliance as these areas are not designed or intended to be
touched and may contain sharp or rough edges that could cause
injury.
Fitting the Hob
Unpacking the hob:
Take care not to lose or mishandle any parts.
Fitting position of the hob:
This appliance must be installed a minimum of 50mm from any
back wall and a minimum of 180mm away from any adjacent vertical
surfaces, e.g. a tall cupboard end panel. This may be reduced to
100mm if the adjacent surface is resistant to fire (tiles or steel, for
example). These dimensions are shown in Fig. 5.
Ventilation requirements:
This appliance must be installed to allow air to ow freely to the air
intake, from the air outlet and in the base and run of units into which
it is installed (Fig 3). Failure to allow sucient ventilation could cause
damage to the hob and constitutes incorrect installation, which is not
covered by the warranty.
Notes:
This could be a simple slot cut out of the plinth, or a dedicated

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CDA hn3620 and is the answer not in the manual?

CDA hn3620 Specifications

General IconGeneral
BrandCDA
Modelhn3620
CategoryHob
LanguageEnglish

Related product manuals