14
in the relevant zone display after cooking until the zone is at a safe
temperature to touch.
In the event of a power cut, the residual heat indictors will illuminate
after the power supply is restored. However, when there is no power
supply to the hob the residual heat indicators will not work, so extra
care must be taken.
Please note:
You should avoid touching the zones when the hob is in use, or when
an “H” is showing on the zone display.
Pan detection
The hob is equipped with a sensor that will advise when the pan is
removed from the zone, or is unsuitable for use on induction hobs.
The zone display will show “U” until a suitable pan is placed on the
zone. The zone will switch o after approximately one minute if no
suitable pan is placed on the zone.
To Next Page
Loading...
Need help?
General
