14
To turn o the key lock
If the hob is not already turned on, turn it on by touching the
key.
Touch the “-” key and the “Zone selection” key for the front right zone
at the same time, then touch just the “-” key.
The hob beeps to conrm the key lock is switched o, then the hob
switches o. When turning the hob back on the key lock is turned o.
Residual heat indicators
The hob is equipped with residual heat indicators to warn when any
of the zones are still hot to the touch after cooking. An “H” will show
in the relevant zone display after cooking until the zone is at a safe
temperature to touch.
In the event of a power cut, the residual heat indictors will illuminate
after the power supply is restored. However, when there is no power
supply to the hob the residual heat indicators will not work, so extra
care must be taken.
Please note:
You should avoid touching the zones when the hob is in use, or when
an “H” is showing on the zone display.
Pan detection
The hob is equipped with a sensor that will advise when the pan is
removed from the zone, or is unsuitable for use on induction hobs.
The zone display will show “U” until a suitable pan is placed on the
To Next Page
Loading...
Need help?
General
