EasyManuals Logo

CDA hn6110 User Manual

CDA hn6110
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
In the event of a fault with the hob, please advise CDA Customer Care
of any fault code shown on the display
Contact CDA Customer Care
A: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T: 01949 862 012 F: 01949 862 003
E: service@cda.eu W: www.cda.eu
Troubleshooting
On rst use
You observe that Possible Causes What should you do?
The display shows a series
of digits and symbols on first
connection
Working normally
Nothing, the hob will be ready
to use within approximately 10
seconds
Installation blows a fuse or
only one side of the hob works
The electrical connection of the
hob is incorrect
Check that it is set up properly
(see the Electrical Connection
section)
The hob produces an odour
during the first cooking sessions
New appliance
Heat a saucepan full of water
on each cooking zone for 30
minutes
You observe that Possible Causes What should you do?
The hob does not work and the
lights on the control panel do not
switch on.
The hob is not connected to
the power supply or the power
supply is faulty.
Check the electrical circuit
breaker and fuses.
The hob is not working and the
display shows a non-standard
graphic.
The electronics are not
functioning correctly.
Call CDA Customer Care.
The hob is not working and all
the zone displays show “L.
The key lock is on.
Switch o the key lock before
trying to use the hob.
9 fast frying steaks
On switching on

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CDA hn6110 and is the answer not in the manual?

CDA hn6110 Specifications

General IconGeneral
BrandCDA
Modelhn6110
CategoryHob
LanguageEnglish

Related product manuals