CDVI ATRIUM ADH10 - Installing the Box Lock

12
cdvigroup.com
EN
ADH10
ATRIUM - Schlage Integration Module (Control up to 10 Schlage Door Handles)
INSTALLATION MANUAL
EN
ADH10
ATRIUM - Schlage Integration Module (Control up to 10 Schlage Door Handles)
INSTALLATION MANUAL
Installing the box lock
Installingtheboxlockallowstosecuretheboxfromnon-authorizedaccess.
Ifneededinstalltheboxlockasshown
in the picture (inside view of the door).
1. Removetheboxdoorknock-out.
2. Insertthelockinthehole.
3. Slidethe“U”metalbracketintothelock
groove as shown in the picture to
 securethelockinplace.
Alternativelyorcomplementarytotheboxlock,
theboxmaybesecuredbyxingthecoverto
its base using screws.
Howeverthisshouldbedoneonlyoncethe
installation of the full 10-Door Handle Controller
systemiscompleted.
1. Use the 4 screws supplied to secure
the box cover to its base as shown
in the following picture.