cecotec Conga 1490 - Cleaning Sensors and Wheels; Cleaning Charging Terminals

ENGLISH
30
Remove the Wet & dry tank.
Lift up the dust tank
handle.
Remove the dust tank
from the Wet&dry tank.
Open the dust tank cover.
Take the primary and
High-efciency lter out.
Empty the dust tank.
Wash the dust tank and
the primary lter using
water. Clean the High-
efciency lter with a
brush, avoid washing it
under water.
Install the primary lter
and the High-efciency
lter into dust tank.
CLEANING SENSORS AND WHEELS
• Use a soft damp cloth to clean wheels and sensors.
CLEANING CHARGING TERMINALS
• Use a soft damp cloth to clean the charging terminals on the
robot and on the charging base.
• Use a dry cloth to wipe the charging bones if the connection is poor.