To Next Page
K
Kimberly MaldonadoSep 13, 2025
How to troubleshoot driving-wheel fault on cecotec CONGA 2299 INERTIAL X-TREME?
- NNicole NormanSep 13, 2025
Check if the driving wheel is blocked.
How to troubleshoot driving-wheel fault on cecotec CONGA 2299 INERTIAL X-TREME?
Check if the driving wheel is blocked.
General| Model | Conga 2299 Inertial X-Treme |
|---|---|
| Category | Vacuum Cleaner |
| Navigation | Inertial |
| Battery Type | Lithium-ion |
| Battery Capacity | 2600 mAh |
| Battery Life | Up to 160 minutes |
| Charging Time | 4-5 hours |
| Control | App & Remote Control |
| Programmable | Yes |
| Suitable Surfaces | Hard floors, carpets |
| Filter Type | HEPA |
| Wet Mopping | Yes |
| Scheduled Cleaning | Yes |
| Virtual Walls | Yes |
| Auto Recharge | Yes |
| Type | Robotic Vacuum Cleaner |
| Technology | Inertial Navigation |
| Operating Modes | Auto, Edge |
| Connectivity | Wi-Fi |
Safe handling, charging, and disposal procedures for the device's lithium-ion battery.
Safety precautions and warnings before operating the robot vacuum cleaner.
Initiate the cleaning cycle for the robot vacuum cleaner.
Pause, resume, or stop the robot vacuum cleaner's cleaning cycle.
Instructions for sending the robot vacuum cleaner back to its charging base.
Procedure for turning off the robot vacuum cleaner when not in use.
Details on various cleaning modes available for the robot vacuum cleaner.
Robot vacuum cleaner cleans automatically, returning to base when battery is low.
Robot vacuum cleaner cleans randomly until battery is low.
Intensive cleaning of a specific spot using spiral motion.
Robot vacuum cleaner cleans along walls and around furniture.
Send the robot vacuum cleaner back to the charging base.
Steer the robot vacuum cleaner manually using the app.
Adjust suction power: Eco, Normal, and Turbo levels.
Program daily cleaning cycles for the robot vacuum cleaner via the app.
Guidance on cleaning and replacing the high-efficiency filter.
Instructions for cleaning and replacing mesh and sponge filters.
How to clean the robot's sensors to ensure proper navigation.
Steps to clean the main brush and remove trapped hair and debris.
Advice on cleaning and replacing the side brushes.
Details about the robot's sensors and their maintenance.
Procedures for battery maintenance, charging, and replacement.
Troubleshooting common errors indicated by beeps and lights, with solutions.
Resolving issues related to the fan and main brush.
Troubleshooting for common issues like non-activation, stopping, low suction, and charging.
Resolving problems with the main brush spinning and unusual robot movements.
