cecotec CONGA 4490 - Wi-Fi Connection Troubleshooting; App-Controlled Cleaning Modes

CONGA 4490 | 37
ENGLESK
Conguration:
Fig. 24
Download the Conga 5000 App from App Store or Play Store.
Create an account with your e-mail and a password.
Conrm login.
Add your Conga robot.
Connect to Wi-Fi.
Warnings:
The Wi-Fi name and password cannot exceed 32 bits.
If the network conguration fails to connect, follow the steps below:
Press the power button for 5 seconds, the robot will enter sleeping mode
and the Wi-Fi light indicator will blink fast indicating connection error. Retry
connecting the robot again following the steps in the before section.
If the connection fails again, check if:
The robot is too far away from the router.
The Wi-Fi password is incorrect.
The following modes can be activated from the App:
Auto mode
Select this mode for the robot fo clean 4x4 m quadrants. Within this space,
it will carry out a rst cleaning cycle in Edge mode and then in zigzag motion
to complete the surface. Once it has nished, it will directly return to the
charging base.
It can be activated from the App or the remote control.
Note: The robot could leave the room to complete the cleaning cycle in some
of the quadrants. This will not aect the robot’s operating, do not worry.
Edge mode
Select this mode for the robot to clean along walls and furniture.
It can be activated from the App or the remote control.
Spiral mode
When this mode is selected, the robot will start cleaning in a specic point,
and then will clean carrying out moves in spiral motion outwards.
It can only be activated from the App.
Scrubbing mode
When this mode is activated, the robot moves in a swaying motion, simulat-
ing real scrubbing moves. It starts o cleaning in Edge mode, then in zigzag
motion and nally returns to the charging base taking the straightest way
back home.