cecotec CONGA 4490 - Area-Specific Cleaning Modes

38 | CONGA 4490
ENGELSK
It can only be activated from the App.
Manual mode
To carry out manual cleaning, use the direction buttons on the remote con-
trol or on the App to take the robot to the specic points where you want it
to clean.
It can be activated from the App or the remote control.
Back home mode
Select this mode at any point of any cleaning cycle and during any of the
modes, the robot will automatically return to the charging base.
It can be activated from the robot, the remote control or the App.
Smart Area mode
Once the home’s map has been saved, select this mode for the robot to clean
a specic area in zigzag motion. The robot will clean the selected area and
then will return directly to the charging base. You can set more than 1 area
at the same time. The robot will only clean the area selected in the map,
therefore it will go to the point and return to the base without vacuuming.
It can only be activated from the App.
Spot mode
Select this mode if you want to thoroughly clean a specic point in the map,
making the most of the robot’s maximum power. The robot will clean a 2x2
m zone in zigzag motion and then will return directly to the charging base
when cleaning is completed. The robot will only clean the area selected on
the map, therefore it will go to the point and return to the base without vac-
uuming.
It can only be activated from the App.
Restricted area mode
Select this mode and delimit in the map specic areas where you do not
want the robot to clean. You can set more than 1 restricted area at the same
time on the map.
It can only be activated from the App.
Twice mode
Use this mode to carry out a deep, thorough cleaning of your home.
It can be combined with Edge, Spiral, Spot or Smart Area modes. The ro-
bot will carry out 2 full cleaning cycles and then will return directly to the
charging base.