CEFLA VENUS PLUS - Replacing the Bulb

15
B
C i
m
EN
OPERATOR’S MANUAL
5.2. REPLACING THE BULB
VENUS PLUS, VENUS PLUS CL version lights only.
WARNING!
Carry out this operation after having cut the power
to the device to which the lamp is connected and
only after it has cooled down.
Operate as follows to replace the bulb:
• remove the handles (see paragraph 3.4.);
• remove the transparent screen (see paragraph 5.1.);
• open the bulb cover after loosening the safety screw
(B) using the male hexagon spanner supplied;
• remove the bulb support (i) after unscrewing the ring
nut (C);
• remove the bulb (m) by gently pulling it outwards;
• insertthenewbulb,makingsurethattheelectrical
pins are driven fully home on the relevant bulb holder;
NOTE: DO NOT touch the new bulb with
your hands, use the appropriate protection to handle
it. If you have inadvertently touched the bulb, use
a wad of cotton wool soaked in alcohol to remove
your ngerprints.
WARNING!
The bulb must comply with the “Technical
specications” listed in the relevant paragraph.
• forretting,followtheremovaloperationsinreverse
order.
WARNING!
Ret the transparent screen and the handles,
paying attention to the relevant safety locking
devices.