What to do if I get an RNS error on my CEFLA Dental equipment?
If you encounter the 'RNS' error with your CEFLA dental equipment, ensure the phantom is filled with water. Then, perform an acquisition of a Blank image, referring to paragraph 8.1.4 "3D image quality controls".
What to do if I get an ALL error on my CEFLA Dental equipment?
If you encounter the 'ALL' error with your CEFLA dental equipment, verify the phantom acquisition during the second scout view. If it is tilted, lift or lower the support to adjust.
What to do if I get an AAP error on my CEFLA Dental equipment?
If you encounter the 'AAP' error with your CEFLA dental equipment, verify the phantom acquisition during the first scout view. If it's tilted, adjust the phantom position.
Comprehensive safety instructions for device use and installation.
Detailed safety precautions including movement, laser, and EM safety.
Detailed instructions and guidance for correct patient positioning.
Specific guidelines for positioning patients for 3D examinations.
Important considerations for performing CBCT exams on pediatric patients.
Guidelines for periodic inspections and quality control.
General| Type | Cone Beam Computed Tomography (CBCT) |
|---|---|
| Detector Type | Flat Panel Detector |
| Field of View (FOV) | 10x10 cm |
| Voxel Size | 0.125 mm to 0.3 mm |
| Scan Time | 5.4 - 24 seconds |
| Radiation Dose | Low dose protocols available |
| Software | NNT Software |
| Patient Positioning | Seated or Standing |
| X-ray Generator | High-frequency generator |
| X-ray Tube Voltage | 90 kV |
| X-ray Tube Current | 3-10 mA |
| Power Requirements | 220-240 V, 50/60 Hz |
To Next Page
