Cellularline U-COM 6R - Bluetooth Intercom Communication; Intercom Pairing Procedure

9
7. BLUETOOTH
®
INTERCOM
7.1 Intercom pairing
U-COM 6R can be paired with up to 3 other UCOM units (or Sena units), as
shown in the following picture.
A
B C D
The pairing is only necessary the rst time, then the control units will
automatically recognize each other.
1. Press and hold the INTERCOM button on boht units A and B for
3seconds, until you hear the voice prompt “intercom pairing”.
The light ashing red indicates the device is now visible.
3 sec
3 sec
A
B
A
B
After few seconds the units will be paired and they will start the intercom
communication. The light on both units will ash blue twice.
2. Repeat the previous step again, pressing the INTERCOM button on
the two units A and C for 3 seconds until you hear the voice prompt
“Intercom pairing”.
3 sec
3 sec
A
C
A
C
3. Repeat the procedure again, pressing the INTERCOM button of the two
units A and D for 3 seconds until you hear the voice prompt “Intercom
pairing”.
3 sec
3 sec
A
D
A
D