SKU 40643 For technical questions, please call 1-800-444-3353. Page 7
Adjusting the Sanding Belt for Vertical Operation
Caution: Never make adjustments to the Sander without first unplugging the line cord
from the electrical outlet.
1. Using a wrench, loosen Nut (12) until the Belt Frame (8) can be moved.
2. Push the Belt Frame to the desired angle (0 to 90 degrees). View Angle Scale.
3. Tighten Nut (12).
4. Begin sanding.
On/Off Switch
The locking On/Off Switch (49) needs to have the switch key inserted before the switch can
be used. This feature prevents unauthorized use of the sander. The Locking Switch operates
as follows.
1. Insert plastic Switch Key into locking Switch (49).
2. Press the Switch to the On position to start.
3. Press the Switch to the Off position to stop.
4. To lock switch in Off position, pull out the key and store in a secure place.
CAUTION: Never walk away from sander when the machine is running.
Always lock the switch in the Off position when not in use.
Nut (12)
Belt Frame (8)
Angle Scale
REV 09/00
To Next Page
Loading...
