16
CM73522UMC.0112
5. How to Use Equipment
5-1. Preparation before Use
(1) Open carrying bag and unpack mixer, tray, battery and AC adaptor.
(2) Insert battery pack into the compartment and close the door.
To operate the equipment by AC power, plug the AC power adaptor in the inlet
on the rear panel.
[Note 1] When both the battery and the AC power adaptor are connected together,
the adaptor supplies operating power and the battery is under recharging.
(3) Put the tray onto tray mount.
(4) Empty the tray, then turn power on.
* The tray rocks once.
* LED lamp is lit.
* LCD panel displays ‘29’ or ‘28’, then it counts down to ‘0’.
[Note 2] If anything is put on the tray when power is turned on, it is tared at zero
count. Tared weights must remain on the tray throughout the procedures.
If any weight is removed, total weight will have an error of an equal
amount.
(5) Wait for 30 seconds until main display registers ‘0’.
* [GRAM] appears to indicate the number displayed is weight in grams.
(6) Equipment is now ready to use.
To Next Page
Loading...