Cerber C816 - Section [090]: “Inactivity Time after that the partitions will autoarm (hours & minutes; hours & minutes); Section [093]: PC Phone Number for callback

60
InactivityTime A
03:00
InactivityTime B
03:00
Choose Sect:
UP/DW C612 psw
0000
UP/DW PC psw
0000
Phone PC
Unprogrammed
The keypad buzzer will sound 3 beeps after each 2-digit group and 6 beeps after the last one. Then the panel exits the section and will wait for a new command.
To exit the “main programming menu”, press [#] key.
Section [090]: “Inactivity Time” after that the partitions will autoarm (hours & minutes / hours & minutes)
Enter 4 groups of 2 digits:
- the first 2 digits for number of hours (00 to 99) and the second 2 digits for number of minutes (00 to 99) after that the partition A will auto arm if no motion will be detected
in the area;
- the third 2 digits for number of hours (00 to 99) and the fourth 2 digits for number of minutes (00 to 99) after that the partition B will auto arm if no motion will be detected
in the area;
The keypad buzzer will sound 3 beeps after each 2-digit group and 6 beeps after the last one. Then the panel exits the section and will wait for a new command.
To exit the “main programming menu”, press [#] key.
Note: If in this section, one of the 2 groups of 2 digits are set both with value 0, then the corresponding partition will try to auto arm after every second if no activity will be detected in the area.
Section [091]: Panel Identification Code within upload/download
Enter 4 digits (HEX digits are NOT allowed), to identify the control panel within upload/download process.
[x][x][x][x] (Default value is [0000])
After entering the 4 digits, keypad buzzer will sound 6 beeps and the panel will exit the section, waiting for a new command to enter another
section.
To exit the “main programming menu”, press [#] key.
Section [092]: PC Identification Code within upload/download
Enter 4 digits (HEX digits are NOT allowed), to identify the control panel within upload/download process.
[x][x][x][x] (Default value is [0000])
After entering the 4 digits, keypad buzzer will sound 6 beeps and the panel will exit the section, waiting for a new command to enter another section.
To exit the “main programming menu”, press [#] key.
Section [093]: PC Phone Number for “callback”
This is the PC phone number that the control panel will dial for “callback process”.
Enter the phone number in the same way it would be dialed on a touch-tone phone. The maximum number of digits is 15.
To confirm the phone number, press [#] key after the last digit of the phone number was entered.
After [#] key pressing, the keypad buzzer will sound 6 confirmation beeps and the panel exits the section and will wait for a new command to enter another section.
, type 2 groups of 2 digits
or
[#]
, type 2 groups of 2 digits
or
[#]