62
2.1 After any digit was pressed, system time and date setting can be canceled by [#] key pressing. After cancellation by [#] key pressing, the keypad buzzer will
sound 6 confirmation beeps and the control panel will go back within “main programming menu”, keeping the old value for system time and date.
3. Leave the main programming menu by [#] key pressing.
Section [096] – Walk Test (service mode)
This command allows to the installer to manually enter the “walk test” mode and test the sensors in the system.
Thus, just entering section [096] will take the system into the “walk test” mode. While the system is in this mode, any zone violation will produce a
“ding sound” on the siren.
After all sensors in the system was tested, press [#] key to exit this testing mode. After [#] key was pressed, the keypad buzzer will sound 6 confirmation beeps and exit
this section waiting for a new command to enter another section or [#] key to exit the main programming menu.
Note: Once the system enters section [096], it will exit this section only after [#] key is entered (the control panel will not leave this section automatically, 2 minutes after the last key pressing
any more).
Section [097]: Manual Activation of PC callback
Entering section [097] allows the installer to manually initiate the PC call to establish the communication between the control
panel and PC. Before entering this section the PC modem must be passed in the waiting status for control panel calls.
Once the installer entered this section, the control panel will dial the “PC phone number”, programmed in section [093]; while the PC modem is called it will “take” the phone line over
and will start to communicate with the control panel. The control panel and PC will verify each over the passwords (the control panel and PC identification codes within
upload/download, programmed in sections [091] and [092]) and, if the passwords are correctly, the communication between the control panel and PC will be activated upon the
control panel initiating.
Notes:
1. This function is identical with [*][8][Master Code][097][#] command, which is allowed to the master user, too.
For a successful initiating of the PC callback, the “PC phone number” needs to be programmed in section [093].
Section [098]: Manual Activation of Communication with PC (PC download acceptance)
This command allows the installer to manually trigger the communication between PC and panel. Before entering this
section the PC modem must be already on the phone line and call the control panel. While PC modem is calling the
control panel, just entering section [098] will manually activate the communication between PC and panel.
. While PC modem is calling the control
panel, just entering section [098] will manually activate the communication between PC and panel.
Notes:
1. This function is identical with [*][8][Master Code][098][#] command, which is allowed to the master user, too.
2. Manually activation of communication with PC (PC download acceptance) is useful when the “Panel answers to remote PC calls” option in section [035] isn’t enabled by programming and
system parameter programming from PC software is still required.
3. This command is also useful in a local connection between the control panel and the PC modem (connection between the control panel and the PC modem without a phone line). In this
case, use the connection below:
To Next Page
Loading...