0-20
PERIODIC MAINTENANCE TABLE
MAINTENANCE CYCLE
(Based on total operating hours or months of truck life cycle,
whichever comes first)
every 1 week 6 12 months
every 40 1000 2000 hours
DRIVE SYSTEM
Wheels
Tyre cuts, damage or uneven treads I ←
Metal chips, pebbles or other foreign matter trapped in tire tread I*, C* I, C ←
Tread depth I* I ←
Tyre pressure (pneumatic tyres) MM←
Hub nut tightening torque TT←
Rim side ring and disc wheel integrity I* I ←
Front and rear wheel bearing abnormal noise and fastening I* I ←
Front axle
Body deformation and damage I
Body to frame fastening I ←
Abnormal noise and fastening I ←
Rear axle
Body deformation and damage I
Body to frame fastening I ←
Abnormal noise and fastening I ←
Axle beam fastening in vehicle longitudinal direction I* I ←
Hub play I* I ←
Mechanical end stroke I ←
Steering cylinders leakage (if present) I* I ←
Steering cylinders integrity and deformation (if present) I ←
Steering cylinders tightening torque (if present) I ←
Steering king pin (if present) I ←
Linkages play (if present) I ←
POWER TRANSMISSION SYSTEM
Drive unit
General condition, integrity, cleaning I, C ←
Oil leakage I ←
Oil level and status I* I ←
Bolts and nuts fastening I
Wheel nuts tightening T* T ←
Motor to transmission fixing bolts tightening torque T ←
Drive unit to frame fixing bolts tightening torque T ←
Oil screw plugs cleaning and tightening T ←
Air breezer condition and cleaning I, C ←
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
