6-4
REAR AXLE & DRIVE UNIT
DISASSEMBLY • REASSEMBLY
Disassembly Procedure
1. Disconnect the battery plug
2. Connect the chains on the mast [Point 1]
3. Remove the bolts of the mast [Point 2]
4. Remove the mast
5. Remove the pins from the tilting cylinders [Point 3]
6. Remove the seat by remove the 4 bolts under the battery cover
7. Remove the rear plastic cover
8. Remove the battery cover by removing the gas spring and the 2 bolts on the OHG [Point 4]
9. Disconnect the cables of the traction motor and remove the 6 screws [Point 5]
10. Connect a chain or belt to the motor [Point 6]
11. Remove the traction motor
12. Remove the 4 screws of the plastic bottom cover of the drive unit [Point 7]
13. Jack up the back of the vehicle [Point 8]
14. Put a hand-pallet under the backward wheel
15. Remove the 6 bolts of the rear axle [Point 9]
16. Extract the rear axle [Point 10]
283 Nm (± 5%)
340 Nm (+7% -3%)
140 Nm (± 5%)
140 Nm (± 10%)
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
