STARTING ENGINE
[1] Mixture --- RICH
[2] Carburetor Heat --- COLD
[3] Master Switch --- ON
[4] Prime --- AS REQUIRED
[5] Throttle --- OPEN 1/8 INCH
[6] Propeller Area --- CLEAR
[7] Ignition Switch --- START
[8] Oil Pressure --- CHECK
[9] Flashing Beacon and
Navigation Lights --- ON as required
[10] Avionics Power Switch --- ON
[11] Radios --- ON
Prime 2 to 6 strokes; none if
engine is warm
BEFORE TAKEOFF
[1] Parking Brake --- SET
[2] Cabin Doors and
Windows --- CLOSED and LOCKED
[3] Flight Controls --- FREE and CORRECT
[4] Flight Instruments --- SET
[5] Fuel Selector Valve --- BOTH
[6] Mixture --- RICH (below 3000 feet)
[7] Elevator Trim and
Rudder Trim --- TAKEOFF
[8] Throttle --- 1700 RPM
a. Magnetos --- CHECK
b. Carburetor Heat --- CHECK (for RPM drop)
c. Engine Instru-
ments and
Ammeter --- CHECK
d. Suction Gauge --- CHECK
[9] Throttle --- 1000 RPM or LESS
[10] Radios --- SET
[11] Autopilot (if installed) --- OFF
[12] Air Conditioner (if
installed) --- OFF
[13] Strobe Lights --- AS DESIRED
[14] Brakes --- RELEASE
RPM drop should not exceed
125 RPM on either magneto or
50 RPM difference between
magnetos
BEFORE TAKEOFF
STARTING ENGINE
FLIGHT SIMULATION USE ONLY
NORMAL PROCEDURES
PAGE 2
SECTION: | 1 | 2 | 3 | 4 | 5 | 6 | SUPP |
To Next Page
Loading...
