SECTION 6 CESSNA
WEIGHT & BALANCE / EQUIPMENT LIST MODEL 182T
The rear bench seat can be removed to access the floorboard
area of the rear cabin. Baggage may then be tied down using ten
tiedown eyebolts to standard attach points located in the interior
area of the airplane (shown in Figure 6-4 , Sheet 2). The maximum
allowable floor loading of the rear cabin area is 200 pounds/square
foot; however, when items with small or sharp support areas are
carried, the installation of a 1/4" plywood floor is recommended to
protect the airplane structure.
The maximum rated load weight capacity for each of the ten tie-
downs is 140 pounds. Rope, strap or cable used for tie-down should
be rated at a minimum of ten times the load weight capacity of the
tie-down fittings used. Weight and balance calculations for items in
the area of the rear seat and baggage area can be figured on the
Loading Graph using the lines labeled 2nd Row Passengers or
cargo.
6-8 Feb 23/01
To Next Page
Loading...
