Cessna 182T 2001 - Introduction

CESSNA SECTION 2 - LIMITATIONS
MODEL 182T FAA APPROVED
INTRODUCTION
Section 2 includes operating limitations, instrument markings,
and basic placards necessary for the safe operation of the airplane,
its engine, standard systems and standard equipment. The
limitations included in this section and in Section 9 have been
approved by the Federal Aviation Administration. Observance of
these operating limitations is required by Federal Aviation
Regulations.
NOTE
Refer to Supplements, Section 9 of this Handbook for
amended operating limitations, operating procedures,
performance data and other necessary information for
airplanes equipped with specific options.
NOTE
The airspeeds listed in the Airspeed Limitations chart
(Figure 2-1) and the Airspeed Indicator Markings chart
(Figure 2-2) are based on Airspeed Calibration data shown
in Section 5 with the normal static source. If the alternate
static source is being used, ample margins should be
observed to allow for the airspeed calibration variations
between the normal and alternate static sources as shown
in Section 5.
The Cessna Model No. 182T is certificated under FAA Type
Certificate No. 3A13.
Apr 30/01 2-3