105
Battery Charging
Remove the battery from the vehicle before charging�
Connect the positive and negative wires from the charger and charge the battery at a rate 1/10th Amp of
the battery capacity� For example, the charging rate for a 10Amp-hour battery would be 1�0 ampere�
Ensure that the battery is fully charged before installation�
WARNING
Do not install a conventional wet-cell battery in this motorcycle� The electrical system will not work
properly and damage will result�
When removing the battery, remove the negative terminal rst, then the positive terminal. When installing,
the connecting order is opposite of battery removal�
NOTE:
When charging a maintenance-free battery, always follow the instructions shown on the label�
Battery maintenance
Apply a mixture of baking soda and water with a soft brush to clean the battery top and terminals�
Clean away dirt and any corrosion on positive and negative wire terminals with a sti brush.
A special battery charger ( constant low voltage / ampere ) is required for recharging low-maintenance
batteries� Using a conventional battery charger may shorten the battery life�
If the vehicle will not be used for a month or longer, take out the battery and store it in a cool, dry place�
Completely recharge the battery before re-installation� When charging the battery, it should be taken out
from the vehicle�
To Next Page
Loading...
