112
Washing Vehicle
• Rinse with cold water to remove any loose dirt�
• Mix a mild detergent specic for motorcycles or automobiles with water in bucket. Use a soft cloth
or sponge to wash your motorcycle� If necessary, use a mild degreaser to remove any oil or grease
build-up� Start at the top of the motorcycle and wash bottom parts last�
• After washing, rinse your motorcycle with clean water to remove any residue (residue from the
detergent can damage the components of your motorcycle)�
• Dry o your motorcycle with a soft cloth to avoid scratches.
• Start the engine and allow it idle for several minutes. The heat from the engine will help dry o the
vehicle in moist areas�
• Carefully ride the motorcycle at a low speed and apply the brake several times� This will help to dry
the brakes and restores their normal operating performance�
• Lubricate the drive chain to prevent rusting�
NOTE:
When riding in areas where the roads are salted or near the ocean, clean the motorcycle after your ride
with cold water immediately� Do not use warm water to wash your vehicle as it accelerates the chemical
reaction of the salt� After drying the vehicle, applying an anti-corrosion spray to all metal or chrome
surfaces will help prevent corrosion� In the case of riding during a rainy day or just washing the motorcycle,
condensation may form on the inside of the headlight lens� If this happens, start the engine and turn on the
headlight to remove the moisture�
To Next Page
Loading...
