CF MOTO 300CL-X - Page 77

77
CAUTION
Before mounting the oil lter cover, applying a thin layer of oil
on the seal ring prevents the lter from becoming stuck on the
engine case�
Clean the oil drain bolt and the area around the oil drain hole�
Place a new washer on the oil drain bolt, then reinstall it� Torque
the drain bolt to specication
(
25N•m
)
�
Remove the oil lling screw plug
3
�
Fill with engine oil (SAE10W/40 SJ JASOMA2) by 1�47 qt (1�4 L)
oil�
Remount the oil lling screw plug.
Start and idle the engine for several minutes, allowing the oil to
ow into the oil lter while checking for leaks.
Turn o󰀨 the engine.
Inspect the oil level and adjust according to the level result�
3