CH M1.1 - Returning to Factory Defaults

Slave
Custom
This networking facility allows information sharing among CH
products.
ROOM NUMBER 1
…
7
Define the room in which room the M1.1 is (multiroom
applications).
This prevents CH Precision units connected to the same network
but located in different systems/rooms to interact with each
others.
IP SETTINGS Auto (DHCP)
Direct-Link
Manual
Auto should be selected if the M1.1 is connected to a router with
DHCP server feature.
WAKE-ON-LAN No
Only if PoE
Yes
If No is selected, the M1.1 can't be woken up by the app.
Standby mode will consume less than 0.5W.
When Only if PoE is selected, the M1can only be waken by the
app if connected to a Power-over-Ethernet switch. Standby mode
will draw less than 0.5W from the mains plug.
If Yes is selected, the M1.1 can always be woken up by the app.
Standby mode will draw a couple of watts from the mains plug.
Details of NETWORK menu Parameters
4.4 Returning to factory defaults
The unit can be reset to the Factory default settings by using the RESET ALL SETTINGS item from the FACTORY SETTINGS menu. For
a list of Factory default settings, please refer to the Specifications section.
Rev 3.0 M1.1 User Manual 37