4. Prepare and insert the USB key containing the appropriate firmware image for your unit (as detailed above).
5. Keep the firmware update push-button (located next to the USB receptacle at the back of the unit) pushed while
powering-up the unit (by setting the Power on/off switch to on).
6. The unit will start up in firmware update mode and will update its internal firmware with the image present on the
USB stick. Do not interrupt or unplug the unit until the firmware update is finished. This typically takes about 5
seconds.
7. Once the firmware update is finished, the units goes into standby mode. You can then remove the USB stick.
8. To verify that the firmware update was successful, you can press the other push-button once. The current firmware in
use will be displayed.
9. Switch off the X1 unit (Power on/off switch to off) before plugging back CH Precision component(s) to be powered by
the X1 unit.
Note: The firmware update process can last several seconds, do NOT interrupt it!
If the firmware update procedure fails, try to download the latest software images from www.ch-precision.com, use another USB
stick, and rerun the firmware update procedure (don't forget to prepare the software update files and USB stick accordingly). If
failure persists, contact your authorized dealer.
20 X1 User Manual Rev 2.1
To Next Page
Loading...