CH X1 - 2 Before use; 2.1 Package content; 2.2 Safety notice

2 Before use
Please read this manual carefully before making connections or operating your X1. After reading this manual, please store it in an
accessible place for future reference. If after reading this manual you feel unsure about how to make connections or how to
operate the unit, please contact your authorized dealer for assistance.
2.1 Package content
Make sure that the package content is complete. If not, please contact your authorized dealer. Your package should contain:
• The X1 external power supply unit
• One or two Power Link Cables (configuration-dependent)
• A power cord
• Four adjustment steel spikes
• A suction cup (used to unscrew the top covers)
• An accessory box containing:
◦ a spike adjustment screwdriver
◦ a Torx 10 screwdriver
◦ four stacking covers
◦ a USB stick containing the latest CH Precision firmwares.
◦ four CH Support Discs
Please store the packaging for future transportation. Check your X1 external power supply for apparent damages. In case of
damage, please contact your authorized dealer. If your X1 is still very cold following transport, please let it warm up to room
temperature before powering it up (in order to avoid condensation inside the unit).
2.2 Safety notice
Make sure to observe the following rules:
• Install your X1 external power supply unit on a stable base
• Do not install your X1 near water
Rev 2.1 X1 User Manual 9