Chamberlain 7200 - Operation of Your Opener; Activate the Opener; Door Control Features

Operation
of
Your
OPener
Activate
the
opener
with any
of the
following:
.
The
Remote
Control.
Hold
push
button
down
until
the
door
starts
to move.
.
The Door
Gontrol.
Hold
push
bar
or button
down
until
the door
starts
to
move.
.
The
Outside
Keylock
or
Keyless
Entry.
(See
Accessories)
When the
opener
is activated
with
the safety
reversing
sensor
installed
and
correctly
aligned:
l. lf open,
door
will close.
lf closed,
the door
will
open.
2.
lf closing,
the
door
will reverse.
3.
lf opening,
the
door
will
stop
(allowing space
for
entry
and
exit
of
pets
and
for fresh
air).
4.
lf
the
door
has
been
stopped
in a
partially
open
position,
it
will close.
5.
lf obstructed
while
closing,
the
door
will
reverse.
6.
lf obstructed
while
opening,
the
door
will stop.
7.The
garage
door
will reverse
in the
closing
cycle
when the
invisible
beam
is broken.
lf fully
open,
the
door
will
not close
when the
beam
is broken.
Sensor
has
no effect
in the
opening
cycle.
lf the
sensor
is not
installed
or aligned
correctly,
you
can't
close
the
door
from
any
remote
control
transmitter.
You
can
close
the door
with the
Door
Control,
the
Outside
Keylock,
or
Keyless
Entry,
however,
if
you
activate
them
until
down
travel
is
complete.
lf
you
release
them
too
soon,
the
door
will
reverse.
The
opener
lights
will blink
for 5 seconds
when
the
safety
reversing
sensor
causes
the
door
to
reverse.
The
Opener
Lights
will turn
on
under
the
following
conditions:
When
the
opener
is initially
plugged in;
when the
power
is interrupted;
when
the
opener
is
activated.
They
will
turn off
automatically
after
4-112
minutes
or
provide
constant
light
when
the
Light
Feature
is activated.
Bulb size
is
75
watts
maximum.
Trolley
Release
Arm
Trolley
Manual
Release
Handle
(Pull
Down)
Manual
disconnect
position
The
lockout
feature
prevents
the
trolleY
from
reconnecting
automat-
ically.
Pullthe
manual
release
handle
down
and
back
(toward the
opener).
The
door
can
then
be
raised
and
lowered
manually
as
often
as
necessary.
To
disengage
the
Lockout
Feature,
pull
the
manual
release
handle
straight
down.
The
trolleY
will
reconnect
on the
next
UP
or
DOWN
operation.
+
To
open
the door
manually:
The
door should
be
fully
closed
if
possible.
Pull down
on
the
manual
release
handle
and
lift the door
manually.
To
reconnect
the door
to
the
opener,
press
the
Door
Control
push
bar
or
button.
Trolley
Release
Arm
Trolley
Manual
Release
Handle
(Pull
Down &
Back
Towards
Opener)
Lockout
position
Operation
of
the
Door Gontrols
(both
are
not
included
with
all models)
Lighted
Door
Control
Bùtton;
Lock
Feature
-
Door Gontrol
Panel:
The
Lock
l-iitrtea
push
Bar
-
Door
Gontrot
Panel:
Press
to
feature
is
designed
to
prevent
operation
of the
door
opän
o,-
close
the
door.
from
remote
controls.
However,
the
door
will open
Press
again
to
reverse
the
door
during
the
closing
yd.
?l?t?
from
the
Door
control
push
bar'
the
cycle
or
to sfop
the
door
while
it's
opening.
Outside
Keylock
and the
Keyless
Entry
Accessories'
Light
Feature
-
Door
Gontrol
Panel:
Press
the
To Activate:
Press
and
hold
the Lock
button
for
Light
button.
tf
the
opener
tight is
off,
itwittt";;';;.
2 seconds'
The
push
bar
lightwillflash
as
long
as
tf the
opener
light
is
on,
(even in the
4-1l2t¡nrt"
y"::-:n
feature
is on'
automatic
cycle)
it
will tuin
orï.
To turn
off:
Press
and
hold
the Lock
button
Bur
if
you
use
the
Lisht
button
to
turn
the
risht(s)
on
î:3ilJ;:í¿"i3llì;Li?JÏ,iiffå
Tril
wìrr stop
and
then
activate
the
opener,
the
light(s)
will
turn
off
*Àán"i"r
the
"Smart"
button
on the
opener
panel
after
4-112
minutes.
is activated.
The
Light
button
will
not control
the
opener
lights
when the
door
is in
motion.
Weak
or
broken
springs
could
allow
an
open
door
to
falt
(either rapidly
or unexpectedly),
resulting
in serious
iniury,
death
or
property
damage.
lf
possible,
use
the
manual
release
rope
and
handle
only
when
door
is
fully
closed.
32
Nortek, Exhibit 1012