39
Operation
Using the Door Control
LOCK
Your remote controls will NOT work when LOCK
mode is active however your keyless entry will
still allow access to your garage.
Activate:
Press and hold the LOCK button for 2 seconds.
The command LED will flash as long as the lock
feature is activated and your handheld remote
control will not operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2
seconds. The command LED will stop flashing
and normal operation will resume.
MAINTENANCE ALERT SYSTEM (MAS):
Activate/Deactivate:
Press and hold the LEARN button. Then press the
LIGHT button. The service LED will flash the
status; Active is 2 flashes and deactivated is 3
flashes.
LEARN
Button
LIGHT
Button
Service
LED
To Next Page
Loading...
