is a small tilt sensor that is installed on the top panel of the garage door on the inside of the garage. When it is in a
vertical position, the sensor reads as Closed, and when it is in a horizontal position it reads as Open.
The MyQ Door Sensor uses a 3 volt CR2450 Lithium battery. Battery level is measured by the MyQ Smart Garage Hub
as the number of cycles (up and down) that the sensor has transmitted since it was first learned into a MyQ Smart
Garage Hub. The MyQ Garage Door Sensor reports low battery at 7,000 cycles. It typically stops functioning due to
battery depletion after about 10,000 cycles.
The sensor communicates with the hub via Bluetooth. This gives it an operating range of about 30 feet from the hub.
Important: The door sensor must be mounted prior to connecting the MyQ Smart Garage Hub to Alarm.com.
There are two Door Sensor installation methods:
Method 1: Use fastening strips
To install the door sensor using fastening strips:
• Position the door sensor vertically and attach to a clean, dry location on the top panel of the garage door with
fastening strips (provided).
Method 2: Use screws
To install the door sensor using screws:
1. Press in the bottom of the door sensor and remove the front cover.
2. Position the door sensor vertically and attach to the top panel of the garage door with screws (provided).
3. Replace the front cover.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Garage/LiftMaster_MyQ_Smart_Garage_Hub/LiftM…
Updated: Tue, 05 Jan 2021 16:24:44 GMT
4
To Next Page
Loading...
Need help?
General
