Chamberlain PD220 - Using Your Garage Door Opener; Remote Control Operation; Add, Reprogram, or Change Remote Control;Keyless Entry PIN

31
Operation
Using Your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control, remote control, or
wirelesskeyless entry.
When the door is closed and the garage door opener is activated the door will open. Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door is in any position other
than closed and the garage door opener is activated the door will close.If the garage door opener
sensesan obstruction while closing, the door will reverse.If the obstruction interruptsthe sensor beam
the garage door opener lights will blink 10 times. However, you can close the door if you hold the button
on the door control or keyless entryuntil the door is fully closed. The safetyreversing sensors do not
affectthe opening cycle.
The safety reversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
Using the Push Button Door Control
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door opener,
press the push button until the garage door opener activates (it may take up to 3 presses).
Push Button
Remote Control
Your remote controlhas been programmed at the factory to operate with your garage dooropener.
Older Chamberlain remote controls are NOT compatible. Programming can be done through the learn
button on the garage door opener.To program additional accessoriesrefer to the instructions provided
with the accessory or visit www.chamberlain.com.If your vehicle is equipped with HomeLink
®
, a
CompatabilityBridge
TM
(notincluded) maybe necessary for certain vehicles. Visit
bridge.chamberlain.com to find outif a Bridge isneeded.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
1. Pressand immediatelyrelease the Learn button.
2. Remote Control:
Press and hold the button on the remote control that you wish to use.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entrykeypad.
Then press the ENTER button.
The garage door opener lights will flash (or two clickswill be heard) when the code has been
programmed. Repeatthe steps for programming additional remote controls or keyless entrydevices.
“click”
“click”
1
2
LEARN LED
LEARN
Button
OR
PIN
? ?
? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
Q
Z
*
#
E
NT
E
R
0
QZ
*
#
ENTER
6
MNO