18
Installation
STEP10 Install the door control
To preventpossible SERIOUS INJURY or DEATH from electrocution:
l Be sure power is NOT connected BEFORE installing door control.
l ConnectONLY to 12 VOLT low voltage wires.
To preventpossible SERIOUS INJURY or DEATH from a closing garage door:
l Install door control within sight of garage door, outof reach of children at a minimum height of 5
feet (1.5 m), and away from ALL moving parts of door.
l NEVER permit children to operate or playwith door control push buttonsor remote control
transmitters.
l Activate door ONLY when it can be seen clearly,is properlyadjusted, and there are no
obstructions to door travel.
l ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path
of closing garage door.
INTRODUCTION
Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children
cannotreach, and away from the moving parts of the door.
NOTE: Your product may look different than the illustrations.
1. Strip 1/4" (6 mm) of insulation from one end ofthe wire and separate the wires.
2. Connectone wire to each of the two screws on the back of the door control. The wires can be
connected to either screw.
3. Mount the door control with the hardware provided.
To Next Page
Loading...
Need help?
General
