33
Maintenance
Maintenance Schedule
EVERY MONTH
• Manually operate door. If it is unbalanced or binding,call a trained door systemstechnician.
• Checkto be sure door opens and closesfully. Adjustifnecessary,see page 26.
• Testthe safetyreversal system.Adjustif necessary,see page 28.
EVERY YEAR
• Oil door rollers,bearings and hinges.The garage door opener does notrequire additional
lubrication. Do not grease the door tracks.
The Remote Control Battery
To preventpossible SERIOUS INJURY or DEATH:
l NEVER allowsmall children near batteries.
l If battery is swallowed,immediately notifydoctor.
To reduce riskof fire, explosion or chemical burn:
l Replace ONLY with 3V CR2032 coin batteries.
l DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
The 3V CR2032 lithium battery should produce power for up to 3
years.If the battery is low, the remote control’s LED will notflash
when the button is pressed.
To replace battery, pry open the case first in the middle (1), then at
each side (2 and 3) with the visor clip.Replace the batteries with
only3V CR2032 coin cell batteries.Insert battery positive side up.
Dispose of old batteries properly.
NOTICE:This device complies with Part15 of the FCC rulesand IndustryCanada (IC)licence-exempt RSSstandard(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received,including interferencethat maycause undesired operation.
Anychangesormodificationsnotexpresslyapproved bythe partyresponsible forcompliance could void the user'sauthorityto operate
the equipment.
ThisClassBdigitalapparatuscomplieswith Canadian ICES-003.
Repair Parts
Description Part No.
1 Logic board 047DCT
2 Lightlens 041D0166
3 Hardware bag 041A8068
4 Door arm kit: straight door arm, curved door arm, hardware bag 041A8094
5 Door control 041A7367-3