A
8
Advanced Settings - Softener
1
3
5
7
9
2
4
6
8
10
Advanced Settings - Aeration Filter
1
3
4
6
8
2
5
7
1. Days left until next regeneration based on Regeneration Day Over-
ride
2. Amount of days between regeneration can set between 0-29. Set
ting at 0 turns this feature off
3. Percentage of soft water saved in case system runs out before next
regeneration time
4. Capacity of system based on size of tank. This is preset at factory
and should never need to be adjusted.
5. Turns the display off until a button is pressed
6. Turning this on adjust the cycles to have the forth regeneration step
tank dry until a regeneration is needed.
7. An upflow cycle to clean the media bed
8. Draws in salty water from the brine tank and rinses it over the media
bed to rejuvenate the resin
9. A downflow cycle to re-compact the media bed
10. Fills the brine tank with water for the next regeneration
1. How often the system adds air to the water
2. Turns the display off until a button is pressed
3. How much the system draws a chemical if the system is setup for
that feature.
4. Non-Adjustable step for purging air out of the system
5. An upflow cycle to clean the media bed
7. Draws air and/or chemical into the media bed to oxidize and remove
any contaminants
8. A downflow cycle to re-compact the media bed
NOTE:
Advance Settings Page
Chandler Systems
8
To Next Page
Loading...