201-00-16 Suspension System-General Information
Diagnosis and Testing (Continued)
•Loosening and abrasion of the
suspension device assembly
•Check the suspension device
assembly. See this section for
relevant information.
• Loosening of the bracket for the
suspension device assembly
•Fasten according to the torque
requirements. See Sections 201-01
(former) and 201-02 (latter) for
relevant information.
• Abrasion of the ball head of the
lower cross arm
• Replace the ball head of the front
lower cross arm. See Section
201-01 for relevant information.
• Abrasion and loosening of the bush
of the lower cross arm of the front
suspension
•Replace the axle bushing of the
lower cross arm of the front
suspension. See Section 201-01 for
relevant information.
• Abrasion of the axle bushing of the
direction stabilizing rod (if
equipped)
•Replace the axle bushing or
connecting rod of the direction
stabilizing rod. See sections 201-01
(former) and 201-02 (latter) for
relevant information.
• Abrasion or loosening of the rear
suspension and the axle bushing
• Replace the rear suspension and the
axle bushing if necessary. (Section
201-02)
• Abrasion of the wheel bearing
• Replace the wheel bearing. See
Sections 203-01 (former) and
203-02 (latter) for relevant
information.
• Derivation •Damage of the rear suspension
•Repair or replace the parts of the
rear suspension if necessary. See
Section 201-02 for relevant
information.
•The kingpin caster angle is not in
the regulated scope.
• Perform tyre positioning. See this
section for relevant information.
Impact Derivation
• Loosening or abrasion of the
installation supporting frame and
the bearings of the steering
mechanism
• Repair or replace the installation
bracket and the axle bushing if
necessary. See Section 204-02 for
relevant information.
• Loosening and abrasion of the front
suspension assembly
•Repair or replace the front
suspension assembly if necessary.
See Section 201-01 for relevant
information.
•Noise of the Front and Rear
Suspension
• Loosening or abrasion of the
suspension assembly bracket
•Repair or replace the bracket if
necessary. See Sections 201-01
(former) and 201-02 (latter) for
relevant information.
• Abrasion of the wheel bearing
• Check the wheel bearing. See
Sections 203-01 (former) and
203-02 (latter) for relevant
information.
Benni Mini
To Next Page
Loading...
