Changan BENNI MINI 2011 - Page 44

201-00-16 Suspension System-General Information
Diagnosis and Testing (Continued)
Fixed Point Inspection G: Vibration
Phenomena Concrete Procedures/Results/Measures
G1: Check the tyre
1 Hoist the automobile. See Section 100-02 for
relevant information.
- Check the damage or excessive wear of
the tyre.
Is the tyre damaged or excessively worn?
Yes
Replace tyre. Test and run the system to
determine if it is normal.
No
Switch to G2
G2: Check front wheel bearings
1 Check the front wheel bearings.
- Hold the bottom and top of wheel and
sway forcefully. Check if bearings excessively
loosen.
- Rotate the front wheels. Check the
working status of the front wheels.
Do bearings loosen or have sound?
Yes
Switch to G3
No
Switch to G4
G3: Measure the axial clearance of the front wheel bearing
1 Disassemble the wheels, the brake calipers and
the brake disc.
- Install the dial gauge with the installing
bracket, and ensure it to abut against wheel
hub of the front wheel.
- Axially push and pull the wheel hub, and
check the axial clearance of the wheel hub and
the front wheel bearing.
• Is axial clearance of the front wheel bearing in
the specification value?
Yes
Benni Mini