205-04-6 Driving Axle 205-04-6
DIAGNOSIS AND TESTING (Continued)
BENNI MINI
Phenomena
Possible faults
Measures
•Three-ball-pin type universal joint is
parted from the sliding ball cage
joint
• The retaining ring of the driving
axle drops off or incorrectly
mounted in the differential gear
• Replace the retaining ring
• The engine and the speed changer
are not correctly mounted.
• Check the installation bracket of the
engine for damages and wears
• Auxiliary vehicle frame or the
chassis is distorted or bended
• Measure the chassis
• Components of the front suspension
are worn or damaged
• Check the shaft lining for wear or
check the components for
distortion(stabilizing rod,
suspended arm, etc.), make
replacement if necessary
To Next Page
Loading...
