202-01-7 Driving Axle 202-01-7
DISASEMBING AND INSATLLATION
BENNI MINI
REMOVAL AND INSTALLATION
Driving axle (left)
To use the special tool: puller（CA201-006）
General tool
Two-claw puller
Dismounting
1. Warning: The hexagonal socket wrench Is
used to prevent the piston rod from
rotating.
The fixing nuts of the front left supporting
column are loosened
2. The wheels and tyres are dismounted. See
Chapter 201-03for relevant information.
3. Warning: The wheel hub fixing nuts are
dismounted by using the socket and prevented from
being damaged.
1.The wheel hub nuts and washers are loosened.
4. The front oscillating arm ball joint are taken out
from the steering knuckle.
5.
Caution: The driving axle should be well
protected for fear that the constant speed
universal joint is damaged. The working
angle of the internal constant speed
universal joint should not be more than
22.5 degrees. The working angle of the
external constant speed universal joint
should not be more than 45 degrees.
Use the suitable two-claw puller. The driving
axle is taken out from the wheel hub.
To Next Page
Loading...
