202-01-8 Driving Axle 202-01-8
DISASSEMBLING AND INSTALLATION (Continued)
BENNI MINI
6. Caution: The driving axle should be well
protected for preventing the constant speed
universal joint from being damaged. The
working angle of the internal constant
speed universal joint should not be more
than 22.5 degrees. The working angle of the
external constant speed universal joint
should not be more than 45 degrees.
Caution: Make sure that the oil seal of the
driving axle is not damaged.
The driving axle is dismounted from the
variator by applying skillful strength. •
The transmission oil is allowed to be discharged
into a suitable container.
Installation
1.
Caution: The driving axle should be well
protected for preventing the constant speed
universal joint from being damaged. The
working angle of the internal constant
speed universal joint should not be more
than 22.5 degrees. The working angle of the
external constant speed universal joint
should not be more than 45 degrees.
Caution: When the driving axle is inserted,
the installation device of the oil seals
(supplied with the oil seal) should be used
to protect the oil seal of the driving axle.
Note: New retaining ring is installed.
Note: Make sure the retaining ring is installed in the
groove.
The driving axle is installed on the driving axle.
To Next Page
Loading...
