To Next Page

To Previous Page

iGage X9x User Manual page 25 of 53

Provisioning GSM SIM Card in Data Collector

A network connection is required to use an X9x receiver in an RTK Network. You can use many methods to connect a rover to the

network:

 MiFi Wireless Hotspot

 cell phone Hotspot

 GSM SIM card directly the head

 CDMA modem in the data collector

 GSM SIM card in the data collector

This section describes the last method: “GSM SIM card in the data collector.”

If you choose to install the SIM card in the data collector, you will need to do a one-time provisioning to get the data collector ‘on

the internet.’

Step-by-step instructions follow.

1. Procure an activated GSM SIM card.

2. Turn off the data collector, remove the battery and

insert your SIM card:

Note the gold contacts are down and the clipped

edge goes in last on the LT30. Other data

collectors may have a different card orientation.

3. Click on the ‘Connections’ icon (1):

then on the ‘Wireless Manager’ link (2).

4. Make sure the Phone is enabled (On or Open):

5. Click on ‘Menu’, then ‘Phone Settings’:

CHC X91+ User Manual

Questions and Answers: