CHCNAV i50 - 2.6 Connecting to an Office Computer; 2.7 Connecting to a Controller

Getting Started with i50
CHCNAV i50 GNSS USER GUIDE | 2018-11 P a g e | 19
Transport Hard Case
2.6 Connecting to an Office Computer
The receiver can be connected to an office computer for serial data transfer or settings
via a GPS to PC Data Cable. Before you connect to the office computer, ensure that the
receiver is powered on by internal battery or external power.
The following figure shows how to connect to the computer for serial data transfer or
settings:
2.7 Connecting to a Controller
2.7.1 Connecting via Wi-Fi with LandStar 7 Software
Turn on the controller → run LandStar 7 → go to Config main menu → tap Connect.
In the Connect screen, select CHC for the Manufacture field, i50 for Device Type field,
WIFI for Connection Type field.
GPS to PC Data Cable