Check Point L-71 - Page 107

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 107
Steps for the system administrator of this Check Point Appliance:
1.
On this page, set Local URLs Lists Management to ON.
2.
Add URLs/IP addresses or regular expressions to the predefined URLs lists (the custom
applications defined in Security Management Server).
Note - The names of the predefined URLs lists does NOT show the LOCAL_ prefix that was
used to define the application in Security Management Server.
For example, LOCAL_whitelist is shown as just whitelist.
Important -
• If Application Control is turned off or no custom applications have been defined in the
Security Management Server, this page is empty and shows a message that informs
that local URLs can only be defined after URLs lists are predefined in the appliance's
security policy.
• If a list was removed or renamed in the Security Management Server, a warning
shows above the table and next to the URLs List in the table.
To create a new URLs list entry:
1.
Click New.
2.
Select URL/IP Address or Regular Expressions.
The New URL/IP Address or New Regular Expressions window opens.
3.
Select the applicable URLs list from the list.
4.
Enter a URL/IP Address or a regular expression for the URLs list.
5.
Click Apply.
The URL is added to the list of entries for the specified URLs list in the table.
To edit a URLs list entry:
1.
Select an entry from the list.
2.
Click Edit.
3.
Make the necessary changes.
4.
Click Apply.
To delete a URLs list entry:
1.
Select an entry from the list.
2.
Click Delete.
3.
Click Yes in the confirmation message.
To filter for a specified URLs list:
Do one of these:
• In the All Lists box, select the URLs list.
• In the Type to filter field, enter the URLs list name to shows matching results.